Clustered JBoss configuration

<< Click to Display Table of Contents >>

Navigation:  Bizagi Engine > Bizagi system administration > Bizagi server configuration > Bizagi Engine JEE platform configuration > Configuring a JEE application server to work with Bizagi > JBoss configuration >

Clustered JBoss configuration

Introducción

When using Bizagi Engine in a JEE platform, your processes can be configured to run in different JEE Application servers, such as WebSphere, WebLogic, or JBoss. The steps to configure each Application server to work with Bizagi will slightly vary according to the very same differences within each Application server.

 

This section focuses on JBoss configuration's to work with Bizagi in a cluster setup, that is, relying on high availability to make use of more than 1 node for load balancing purposes.

 

 

JBoss_EAP_cluster

 

 

If you wish to configure Weblogic as a standalone server (only using 1 instance without load balancing capabilties), refer to Standard JBoss configuration.

 

 

What you need to do

To configure Bizagi's solution in a cluster, you will need to:

 

1. Configure JBoss to work with Bizagi.

The corresponding steps are described at Configuring JBoss in a cluster to work with Bizagi.

 

2. Configure the Scheduler service for a cluster setup.

The corresponding steps are described at Configuring the Scheduler in JBoss.

 

3. Configure any additional components which are part of the system architecture, such as the load balancer.

For this, follow what described at Setting up the system architecture, in which further infrastructure possibilities are presented.